PDA

View Full Version : Big Block Ford stuff



ssmike
01-08-2006, 05:32 PM
I have some used parts.....
Torker 460 manifold with carb spacer (pic below...)
http://www.***boat.com/image_center/data/500/41IMG_0552.JPG
Mallory Distributor with 9.5 mm MSD plug wires:
http://www.***boat.com/image_center/data/500/41IMG_0561.JPG
Hardin Marine timing chain cover:
http://www.***boat.com/image_center/data/500/41IMG_0554.JPG
http://www.***boat.com/image_center/data/500/41IMG_0553.JPG
I was thinking that somewhere around $175- was fair for the whole deal...I will ship FEDex ground - on the west coast-Az. etc., its very reasonable and will probably be less than $10
Or, if someone wants me to part it out, PM me.
I also have some other parts that I will post in the thread.

Ralph Brunt
01-08-2006, 06:04 PM
interested in all but the manifold sent u a pm thanx ralph

RUSSO
01-08-2006, 06:17 PM
How Much For The Intake..

dmontzsta
01-08-2006, 06:45 PM
I have a rusty timing cover that block off plate can mate to. :)

ssmike
02-08-2006, 04:06 PM
Is anyone interested in this stuff before I list on Ebay?

Schiada Time
02-08-2006, 04:13 PM
Ah. My old big block Ford parts. Mike what did you end up doing with that motor?
Hot Rod Hallett

ssmike
02-08-2006, 04:28 PM
I was wondering what happened to you......I had not seen any recent posts by you.
Here is the motor:
http://www.hotboatpics.com/pics/data/500/5187rc6.jpg http://www.hotboatpics.com/pics/data/500/5187rc8.jpg http://www.hotboatpics.com/pics/data/500/5187rc7.jpg
Almost done.

ssmike
02-09-2006, 04:40 PM
anyone? LOL.

RUSSO
02-12-2006, 06:12 PM
Do You Use A Box For The Mallory??or Stock Set Up Or Just A Coil??i Am Intrested If My Truck..later In The Week If You Still Have It Mayb I Can Swing By And Meet You Some Place..i Drive All Over For Work..so We Can Prob Work Something Out..

ssmike
03-02-2006, 04:52 PM
Russo:
Just a coil, I think.... with that Mallory.
Anyone else interested??? :confused: :confused: :confused: