PDA

View Full Version : Wiring up a Mallory Ignition



AntRant
06-02-2002, 10:01 AM
Ok so ther is 3 wires coming out of the dist. Black, Red, Green, What goes were? And on the coil?

Oldsquirt
06-02-2002, 11:13 AM
AntRant, for specifics I recommend you go to the MALLORY (http://www.mrgasket.com/mallorymain.html) website. Go to instruction sheets.
The general answer is fairly simple:
RED=power from Ignition switch
BLACK=Ground
GREEN= Coil negative
Oh, and the BLACK wire is probably actually BROWN. Mine was on my old Unilite.
[This message has been edited by OLDSQUIRT (edited June 02, 2002).]

david laxton
06-04-2002, 06:32 AM
Make sure you use a resistor on the hot side.
I let the smoke out of 3 modules,not fun.
Had to use 2 resistors to get down to the 7 to 9 running. I now run a MSD and love it.

AntRant
06-04-2002, 01:20 PM
THANKS.....