V drive - prop shaft alignment
I have a 77 Spectra. 24 ft with an Ace Champion v drive gear box. I had to replace the bearings and I have it back in the boat. So I have already read everything I can find about setting up the alignment of the gearbox to the prop shaft hub.But the information I have found are for drives with jacking bolts and solid mounts. Anybody have the procedure for setting up a champion or Casale C500 gear box?
The clearance measurements I am getting seem to be all over the place with the isolator type mounts.
V drive prop shaft alignment
Ok guys, I have a 1995 extended cab sonoma with a two piece drive shaft, Does anyone make a flange that bolts to the flat flange yoke on the rear axle, It is flat with four bolts, I need an after market piece so I can use a u joint