It is a Taylor SS, made in DRumright OK. They are good boats but they are bad about porpusing.
Printable View
It is a Taylor SS, made in DRumright OK. They are good boats but they are bad about porpusing.
did you see them slide it off the rocks:(
had to scare the hell out of them when they hit the rocks, lucky no was hurt or killed from being thrown from the boat into the rocks:eek:
I didn't see them hit the rocks. I didn't even hear about it until they got off the boat and walked up the ramp where I was tying my boat down to the trailer. The guy said "Hope your day went better then ours, our boats on the dam right now" I thought they just broke down, not knowing the severity. I was going to run them out there and see if they could get it going, but it was getting pretty dark at that time. Evidently they came out the next day with, from what I hear 15 boats and a ranger to get it back to the launch area to pull it from the water. I seen this picture later my sister knows the rangers and I was surprised to see it like that, thought it was minor, evidently not. Good thing the rocks are really slick or it could have been much worse...
W:eek: W
I think that may be worse than our prop "incident' above the Needles Bridge:D
Found out yesterday that there was not even a hole in the bottom of the boat. Lucky hu?
Totally amazing!!
Poor Jet Boat Rich, had his hull break just because he came down on a wave too hard!!!:rolleyes: