now, that is another problem. until I get the motor out, the allen head bolts are to close to the u-joint. cant get a big enough allen head in there!! always something!!
Yes you can, you have to customize one of your allen wrenches for the job.
Printable View
now, that is another problem. until I get the motor out, the allen head bolts are to close to the u-joint. cant get a big enough allen head in there!! always something!!
Yes you can, you have to customize one of your allen wrenches for the job.
You might try a ball end allen wrench I've been able to reach them before doing that. You could also try to take the u joint caps off to create more room. Have you tried to rotate the motor to get a better angle? I just got done with pulling a motor from a boat that had the splines frozen, I got lucky and it has a split H bar. Try penetrating oil and a few raps with a hammer.
Good luck, Don
sidewound, that post was hilarious..
:)