Hello jetters,
I'm getting ready to up grade my "e" pump. It sits in a freshly restored 17' Sutphen behind a 450HP 455 with a fresh A impeller, ultimate wear ring and place diverter. Here's my next step:
1. Top loader (HTPs or CPs?)
2. Shoe and ride plate (Any brands other than HTP?)
3. Looking for a split bowl
5. Snoot or droop?
6. Think a stuffer is needed?
Any and all advise will be pondered. Thanks in advance!
-Wade
http://www.savepic.com/freepictureho...n=DCP_0004.jpg
http://www.savepic.com/freepictureho...n=DCP_0020.jpg
Hi Wade, #1- can't help you with. Have never used either one of these. I have never seen a loader help an "E" pump.
#2- you can't install a shoe on a "E" pump, and you should already have a rideplate installed. Hard to see from your pic's.
#3- I have no more good used ones.I will be converting some more soon.
#5- It is called a DroopSnoot.( will generate hull lift )
#6- You will most likely not notice any difference by just installing a stuffer plate. These are used when you start doing perf. work " Blueprint" a pump.
Before I would give you any advice, I would like to know alot more about your boat and what you were trying to achieve. Thanks Neil