Results 1 to 6 of 6

Thread: IMPELLER instalation

  1. #1
    blondebomber
    how hard should a new impeller go on. should it just slide on or do you have to press it on

  2. #2
    promod
    how hard should a new impeller go on. should it just slide on or do you have to press it on
    should just slide on but with no play at all on shaft

  3. #3
    blondebomber
    the one I just took off had to be cut off. Now I'm installing a bronze impeller and it won't go on. :clover:

  4. #4
    Duane HTP
    Take a little emery cloth and make sure the shaft is clean. Then take a ball type brake cylinder hone and hone out the impeller center until it fits.

  5. #5
    blondebomber
    thank you

  6. #6
    promod
    remember lit bit at da time, if ya want to put some antisieze on the shaft where the impeller goes so later on if ya need to take it off it won't be stuck to the shaft, that's always helped me just my .02

Similar Threads

  1. GPS instalation
    By Chickenlips in forum Gear Heads
    Replies: 3
    Last Post: 08-18-2007, 11:35 AM
  2. 496 MAG impeller
    By boatinaz75 in forum Gear Heads
    Replies: 0
    Last Post: 02-12-2007, 11:05 AM
  3. AMT impeller
    By supersoaker509 in forum Jet Boats
    Replies: 2
    Last Post: 01-21-2007, 04:50 PM
  4. Water Pump Instalation How To
    By rockitddman in forum V-Drives
    Replies: 16
    Last Post: 02-13-2006, 05:12 AM
  5. Impeller ??
    By Sleek-Jet in forum Jet Boats
    Replies: 13
    Last Post: 02-08-2003, 07:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •