easy pump pressures install

[texas-19]

Speedway Motors makes a nylon brake line kit that is rated for 1900 psi that i installed on my pump to read intake and bowl pressures.The kit is $30.00 and comes with the line and fittings.It's cheap and easy to install.The line is 25' long.I cut it in half and is plenty long enough to reach the front seats,it reaches up to the deck on my boat.I went to the parts store and purchased a couple of gauges for $15.00 a piece.Total cost was about $70.00 including fittings to hook up gauges.
http://www.***boat.com/image_center/...etpump-med.jpg
Here is a link to the brake line.
http://www.speedwaymotors.com/xq/asp...es+%26+Fitting s/page_name.prod%5Flist%5Fdisplay%2Easp/search_type.L2%7E850/search_option./deptsearch./deptSearch_id.741/dept_id.L2%7E850/dept_id_p.741/dept_name./dept_name_p.Sprint+%26+Midget/ShowImages.yes/sq.0/cont.1/intPgNo.1/redirect./qx/product.htm

[Jake W2]

I think if I were going to do this I would use the push in type of fittings and air line they use on custom truck air bags they will be plenty strong.Because if you take it apart there is no need for new farrels ect.
Texas 19 have you tested it yet?
Jake

[texas-19]

Jake,
Haven't had a chance to test,just installed today.
The kit has a bunch of extra fittings so no problem if you need new farrel fittings.
Really looking forward to hitting the water soon.Will be monday if weather holds out.

[Jake W2]

I was not trying to say what you did was wrong or bad just giving a few options to people. :idea:
Jake

[texas-19]

Easy,sorry if it sounded that way,didn't take your comment in a negative way.

[Jake W2]

no need to be sorry we're good
Jake