-
Looks great Hud. Guess after this weekend I'll be pulling a Tunnel Ram and shipping it off to Fresno for some Cermakrome!
Thanks for the info and the link.
-
That looks great Hud. Was the tunnel ram already sanded and smoothed or did they do it all?
-
-
Junior Member
Bad Meds, I sanded it, but Caps will sand it smooth for you if you like! I didn't know that or I would of had them do the sanding! I'm going to do my header's and all my motor mounts & bellhousing, and driveshaft tube this winter. The picture's don't due it justice.
-
Looks cool but nothing compares to a full polish job. Done right.
-
Junior Member
I agree with that HOSS. But this is half the money!! A lot easier to clean up too!!
[ April 24, 2003, 08:21 PM: Message edited by: Hud ]
-
If you look at Caps Brite site, you will see a photo of Joe Mitchell's 32 Ford roadster engine that I assembled for him. No exhausts in this photo, but even if you look close in person, it is hard to tell what is coated, and what is polished aluminum.
[img]http://www.***boat.com/image_center/data/504/131jim_logo_NEW.jpg[/img]
-
I like it. looks real good.
-
Junior Member
Mike, did you get moved in.
-
Hud:
Mike, did you get moved in. Didn't know I got kicked out.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules