Those headers must make taking the valve covers off a BIIIIOOOOOTCH. Those look like -16 fittings. Mucho $$$ Have you looked into the vacuum pump set-up yet?
This has got to be the most expensive looking Puke Tank configuration ever, no? Those AN fittings alone are worth over a hundred bucks.
Looks bitchen' though!
[img]http://www.***boat.com/image_center/data/500/350Headers_Install_3-med.jpg[/img]
Those headers must make taking the valve covers off a BIIIIOOOOOTCH. Those look like -16 fittings. Mucho $$$ Have you looked into the vacuum pump set-up yet?
Damn Clay....as much as you mention it I might even consider it...LMAO.
E-mail me your digits (Cell#)
Are you going to AVI Casino CBB?
~Ty
Here is my Puke tank set up:
[img]http://www.***boat.com/image_center/data/520/41IMG_1664-med.JPG[/img]
ssmike:
Here is my Puke tank set up:
[img]http://www.***boat.com/image_center/data/520/41IMG_1664-med.JPG[/img] Shoudn't the tank be below the valve covers like ssmike has his. Thats the way mine is.
I kind of like it when they drain back into the valve covers, and I have never had a blow-by problem big enough to warrant any other configuration. I actually put the bungs on the bottom of the tank, and vent on the top.
skeepwerkzaz:
Those headers must make taking the valve covers off a BIIIIOOOOOTCH. Those look like -16 fittings. Mucho $$$ Have you looked into the vacuum pump set-up yet? Those are the same ones I had on the picklefork. Not really all that bad. They just slide down underneath the header.
I think Basset calls them twisties.
Hotcrusader76:
This has got to be the most expensive looking Puke Tank configuration ever, no? Those AN fittings alone are worth over a hundred bucks.
Looks bitchen' though!
[img]http://www.***boat.com/image_center/data/500/350Headers_Install_3-med.jpg[/img]Where have I seen that set-up.....oh yeah! It's MINE! Even valve covers were custom fab'd (okay, modified) so that the breather system snakes around the headers.
Incidentally, I have to agree that those old Sanderson headers wrap a little tightly around the valve covers, and some may find it inconvenient from a maintenance standpoint. Never-the-less, I elected to use them as a styling cue. They're different...I like that.
LO
[ June 19, 2003, 10:50 PM: Message edited by: LakesOnly ]
Thunderbutt:
Shoudn't the tank be below the valve covers like ssmike has his. Thats the way mine is. I have mine mounted higher as well. I built it with stepped internal baffles and a drain on the bottom, inlets on the sides, dash 12 lines. Seemed to do the trick...
Let me ask this. What is the puke tank for? Why do we have it?