Lightning headers for a BB Chevy jet?

[clownpuncher]

Anyone ever install em? Give me a PM, I have a ? or two.
Thanks in advance
ROC

[clownpuncher]

BTW, had to say that Jan and Lightning headers were GREAT. I'd buy em again in a heartbeat. Turns out Jan has some good history as far as performance and jets go.. Great guy and great businessman

[Dan Lorenze]

CP, I'd like to know how you like them once you get them installed.

[clownpuncher]

CP, I'd like to know how you like them once you get them installed.
Well, they're already on and I can tell you I love em. It's my second set.
Check em out here (http://boatheaders.com/) for more technical info.
ROC

[SmokinLowriderSS]

Bolted a set on this past winter and haven't fired them up yet. :cry: :cry:

[Dan Lorenze]

Thanks CP..

[SmokinLowriderSS]

Well, the verdict is, I love 'em. Been dancing carb jets to get her back to being right, and am only 1 size larger, all the way arround, than before. 700CFM holley, jetted 67/77. 3 sizes was way to rich. Starts nice, runs sweet, the sound is REALLY nice thru the 4" outlets (but THOSE are some shin-bashing bastards I can tell ya). Great throttle response.
Gain was honest, 200 RPM, that translates to right about 50 HP. Spun a hard 4,800 last fall, and am spinning 5,000 all this past weekend.
Still have to close the water inlet just a little more, 118* flat out is cooler than I want, 156 idling. Was 130/170 with water thru the logs first and no other changes.

[Cas]

Is there enough clearance with those to get the valve covers off without pulling the headers too?
With my Bassett TT headers, there isn't enough room to get a wrench on bottom bolts of the vc's

[SmokinLowriderSS]

Yes, but it won't be a lot of fun.
I have a set of Mickey Thompson cast Al. valve covers, and they clear, what's more, I have a set of wire looms that used to run OVER the logs (long flat angled taper), slid up between the headers and the covers, and I installed them after the headers were in place, on the aft 2 valve cover bolts.

[jbone]

I guess I'm buying headers this winter.
200 rpm is worth 2k.
Thanks for the info.
J