If you bring them over we may be able to weld some 3.5 reducers on them, if they're short enough to clear the end of the exhaust outlets.
I'm assuming they are stainless fabricated type tips and not cast.
I have a set of through transome tips I want to use , but are 4" od and the boat has logs which I think are 3.5 . Any insight as to how I can make this work if at all .
-beerjet-
If you bring them over we may be able to weld some 3.5 reducers on them, if they're short enough to clear the end of the exhaust outlets.
I'm assuming they are stainless fabricated type tips and not cast.
They are stainless "gil" and was actually going out to your place today but my day was cut short.
-beerjet-
ok, see PM....
hey beerjet some time you can cut the logs back to the 4" od size then dremmel them out a little thats what i did when i had logs they were hardins i think
I'll do a little measuring tomorrow
are they stainless steel tips? what do they look like? reason I'm asking is I have a set of 3 1/2" tips and might consider a trade if'n you're interested?
http://www.eddiemarine.com/cart/Pictures/100_03.jpg
With the cork screw baffle.
-beerjet-
the ones I have aren't that fancy, no baffles and not angled.
If you have some 3 1/2" hose, you can put a piece on the log first and then put the 4" over it.
Beerjet, I run the Rex type reducers, and that's probably the way to go. I have the rex tips too. You might just look into picking up a set of those. They look good, and the flapper set up is trick.