My buddy is running the same combo except the cam. Hes running the 502 502 hp gm roller and his 21ft caliber1 hits 75mph no problem. Cant remember what prop he,s running. Looks like a good combo.
Ok all you experts, do you believe this dyno chart is realistic?
http://www.***boat.com/image_center/...ck_454_Kit.jpg
I found it here. (http://www.strokerengine.com/EdelbrockCombo.html)
My buddy is running the same combo except the cam. Hes running the 502 502 hp gm roller and his 21ft caliber1 hits 75mph no problem. Cant remember what prop he,s running. Looks like a good combo.
If it is, that's a great torque curve. Did it mention compression ratio and fuel needed?
Darrell.
If it is, that's a great torque curve. Did it mention compression ratio and fuel needed?
Darrell.
From here: (http://www.strokerengine.com/EdelbrockCombo.html)
454 Chevy 9.6:1 Engine 1500 to 6500 rpm
The Edelbrock Performer RPM Package
Performer RPM 290cc intake aluminum heads 110cc chambers
Performer RPM cam 234/244 @ .050" .488"/.510" <---this is wrong
Performer RPM manifold
Performer RPM carb 750cfm
Headers 2 1/8"
BBC Edelbrock RPM flat tappet cam has following spec's:
#7162
300°, 306° seat duration
240°, 246° at .050" duration
.560", .573" lift with 1.7 rockers
112° LSA
ICL 110°
ECL 114°
Valve events at .050" :
IVO 10° BTDC
IVC 50° ABDC
EVO 57° BBDC
EVC 9° ATDC
overlap at .050" 19°
So how much HP would you loose running aluminum logs?
I wonder how much HP the heads are worth compared to iron square port heads?
That exact setup DD gives me 514 @ 5500RPM into large tube headers.
542lb torque at 4500RPM. I didn't record the head flow data tho, file was already in the program.
433HP from 5,000 to 5500 into 'HP manifolds w/ mufflers, which seems to be pretty close to the logs.
That exact setup DD gives me 514 @ 5500RPM into large tube headers.
542lb torque at 4500RPM. I didn't record the head flow data tho, file was already in the program.
433HP from 5,000 to 5500 into 'HP manifolds w/ mufflers, which seems to be pretty close to the logs.
So the logs actually cost 80 HP?
I can tell ya they cost me 50, before to after my Lightning headers & 4" outlets. Moderate 454 Mk-IV.
That exact setup DD gives me 514 @ 5500RPM into large tube headers.
542lb torque at 4500RPM. I didn't record the head flow data tho, file was already in the program.
433HP from 5,000 to 5500 into 'HP manifolds w/ mufflers, which seems to be pretty close to the logs.
SS, what does DTDyno show if you use "small tube headers w/ mufflers"?