058 &Fired up
Thanks for that ! In my 16 footter theres only about 1.5 to 2 feet between the block and the drive will the wirlaway fit ? where would I buy one have not seen any in catalogs Kid
V-kid, A Whirl-a-way will add 1.25" to the output shaft of the V-drive if my feeble old memory is correct. It installs between the main case and the in/out cone. They are made and sold by Casale but there is another shaft release made by a co. called Beverfab, Cedar Hill, Tx. Plan on spending about $600.00 not inc. installation.
Originally posted by V-Kid:
HI GUYS
When pulling the top case apart is there anything to watch for or aspecial tool for this job. there seams to be some slack in my casale about 1/8 of a turn between gear to gear is that normal? What is a wirlaway?
Thanks Kid
V-Kid, I make the special tool to remove the top bearing out of the front case. You need to take the bearing out before the cases can be split. Shoot me an e-mail for more info on them.
058 and superdave013
Thanks for that info guys, writing all this in my log .superdave what is your Email addr.
058 and 013 are these your race tags?
Kid
V-Kid, I used to race and yes, my # was 013. I had to put some tape over those # that were painted on my boat for a year and run under #124. Some OTHER guy had lucky 13. That dang LeE ss13 guy had it. lol.
Anyway my address is in my profile but here it is too.
valveautomation1@earthlink.net
I have some exploded views of the v-drive that I can also send you.
"058" numbers came with the boat. I don't race anymore.
Posting Permissions
Reply With Quote