http://www.***boat.com/image_center/...ling_route.jpg
hows that project of yours coming...share some pics
be well
I have a quick question for the knowing. I am hooking up the water lines to the motor. I am trying to find a routing diagram for the Imco's. There are two water ports, one on the bottom of the manifold and one on the down tube. Are these both water inputs. I am assuming they are and the water exits inside of the down tube. The Eddie's and the CMI's have 3 ports, the Imco's only have 2. Now, the water jackets match up, from the manifold to the down tube, meaning that water travels between the two. Can I block off the water ports on the down tubes if the water drains out the down tube exits? So much for the quick question. Any help would be appreciated.
http://www.***boat.com/image_center/...ling_route.jpg
hows that project of yours coming...share some pics
be well
You are the man!!! Thank you very much. The project is tedious but coming along. I want it in upholstery in the next 2-3 weeks. This weekend will tell alot. I am trying not to rush and just take my time and do it right. Hopefully the engine will come to life this weekend. I will post pics once the engine is running and I clean her out. Thanks again!!!