I have a dodge in a 70 eliminator falt. Could i un bolt the motor and rails and bolt it in the hydro?
I REALLY am out of room here and have too many projects going right now. So, rather than have this boat sitting for a year or two (or 3 or 4) I have put it up for sale for $2000.00 minus engine (firm). You can contact me about it via email at JimP@pritek.net or phone; Home 5pm-8pm (530) 668-8915 cell 8am-5pm (530) 312-6535
[ April 22, 2003, 04:33 AM: Message edited by: BigBoyToys ]
I have a dodge in a 70 eliminator falt. Could i un bolt the motor and rails and bolt it in the hydro?
CALIFORNIA PERFORMANCE:
I have a dodge in a 70 eliminator falt. Could i un bolt the motor and rails and bolt it in the hydro? What are the inside demensions of your rails, most hydros are 28"
Dont know the width off hand but what a combs shovel nose with a mopar. You dont see one of those everyday, but i like his cp way too much.
Here's a little more info on the V-drive.... It is a Casale 62160 12 deg in/out, 1" output shaft. Not sure what gears are in it yet, and there is an extra set of gears (18's I believe?)
CALIFORNIA PERFORMANCE:
Dont know the width off hand but what a combs shovel nose with a mopar. You dont see one of those everyday, but i like his cp way too much. My CP is for sale too. It's posted in the Jets Forum.
maybe if I throw an engine int it....
Put it together & run it...
I might be coming home from Ming this weekend with another motor... an 850hp Injected motor. eek! If the deal works out, I might just have to put that motor in the Hydro and run it
BigBoyToys:
I might be coming home from Ming this weekend with another motor... an 850hp Injected motor. eek! If the deal works out, I might just have to put that motor in the Hydro and run it Now your Talkin'.. wink