Reply With QuoteAnd just for the peanut gallery, just because I used the terms "master" and "slave" does not necessarily mean i'm a member of the clan.
F.J.
You say, "does not necessarily mean I'm a member of the clan"
What exactly, do you mean?
I figure there are a few hundred rocket scientist types on here so...........I have a SATA h/d in my pc right now. My brothers P/C crashed so he bought a new rig and sent me his old h/d to see if I can retrieve any of his his files. Question is the hook up. Since my SATA drive is on its own cable set as master and this drive will be on its own IDE ribbon not shared with any other drive do I still set it as the slave? And just for the peanut gallery, just because I used the terms "master" and "slave" does not necessarily mean i'm a member of the clan.
F.J.
And just for the peanut gallery, just because I used the terms "master" and "slave" does not necessarily mean i'm a member of the clan.
F.J.
You say, "does not necessarily mean I'm a member of the clan"
What exactly, do you mean?
You say, "does not necessarily mean I'm a member of the clan"
What exactly, do you mean?
Oh fock, here we go. Do I really need to edit it?
F.J.
Did you ever figure this out? A USB encloser might be the ticket or a pci adapter card. Do you know what MOBO you have. I'm not really understanding what setup you have.
Set it to master, unplug your CD ROM and plug the new HDD where the CD was (or use your empty channel). Start the computer...
Ryph
Set it to master, unplug your CD ROM and plug the new HDD where the CD was (or use your empty channel). Start the computer...
Ryph
What he said. You could also set it CS or pull out the jumper completely and that would probably work.
With most modern drives, you don't even need the jumper installed, but if in doubt set it to master. As long as it's on its own channel (not sharing the IDE cable with the CDROM) it won't affect the SATA drive.
Rob
Did you ever figure this out? A USB encloser might be the ticket or a pci adapter card. Do you know what MOBO you have. I'm not really understanding what setup you have.
The Mobo is a ASUS P4C800E-Deluxe. I can run SATA or IDE and I still have a empty IDE channel so I figured I could just hook it up to that channel and the PC would pick it up as just another storage drive and still boot off the SATA. Am I right? Im going to dick with it on Sunday.
F.J.
The Mobo is a ASUS P4C800E-Deluxe. I can run SATA or IDE and I still have a empty IDE channel so I figured I could just hook it up to that channel and the PC would pick it up as just another storage drive and still boot off the SATA. Am I right? Im going to dick with it on Sunday.
F.J.
yes
to double CMOS on boot to make sure IDE channels are enabled. I have the same board in an SE and run both also.
Posting Permissions