Hydraulic Diverter stop

[Taylorman]

Does anyone know how i can rig up a diverter stop for my hyd. AMT diverter. I want to rig up a stop to for max top speed.
http://i22.photobucket.com/albums/b3...61DCP_5221.jpg

[flat broke]

Mount a small piece of angle onthe port side of the bracket that holds your reverse cable, then run a jamb nut/bolt combo through the angle, so it bottoms out against the steering arm at the desired angle.
While your at it, make some flat shims for your rideplate to cradle mount. Those nuts allow the plate to warp up the middle.
Chris

[Taylorman]

Got it figured out. Works like a charm.
http://i22.photobucket.com/albums/b3...t/DCP_6853.jpg
http://i22.photobucket.com/albums/b3...t/DCP_6854.jpg

[Cs19]

How is this set up working for you?
http://i22.photobucket.com/albums/b3...61DCP_5221.jpg

[inwo]

The more I look, the less I like the hydraulic.
Just ordered the kit for my amt. I think I'll sell the hydraulic. Get a Cable and build an electric with set points.
Or better yet make a servo-feed that tracks a pot on the dash. Maybe a linear pot, or even a joystick.

[Taylorman]

How is this set up working for you?
I like it alot. This is an old picture. I now have no wedges in it and changed to ss hyd lines. This replaced an old jet a vator. I really like the hyd control over the cable.