Results 1 to 8 of 8

Thread: Wanted: 11.5x15 2 blade LH prop for one inch prop shaft

  1. #1
    VDriver66
    Just like the title says. (I believe it's a LH prop that I need. BBC with driveshaft mounted to flywheel) My box has 1.17 gears and the motor is making around 600hp. Would like to go 90mph. Any opinions on if this sounds right? It's a '66 18' hallet circle racer. Thank you!

  2. #2
    VDriver66
    bump

  3. #3
    lilrick
    I have one that is very close. There are no #'s on it so I'm not sure what the pitch is . You are welcome to try it. Where are you located?

  4. #4
    bigheavyd2
    check out www.dragboatcity.com they just got a lot of new 1 in# shaft props in $ 550.00 brand new.

  5. #5
    VDriver66
    bump

  6. #6
    lilrick
    ????????????

  7. #7
    VDriver66
    lilrick,
    sorry for my lack of response. I am in San Jose, Ca. Thanks for the offer..... if only you were a little bit closer!

  8. #8
    Moneypitt
    Just like the title says. (I believe it's a LH prop that I need. BBC with driveshaft mounted to flywheel) My box has 1.17 gears and the motor is making around 600hp. Would like to go 90mph. Any opinions on if this sounds right? It's a '66 18' hallet circle racer. Thank you!
    L/H prop on a "circle racer" ??????? MP

Similar Threads

  1. like new 15 inch 3 blade stainless prop
    By badbug in forum Parts 4 Sale
    Replies: 0
    Last Post: 09-12-2007, 09:26 AM
  2. v drive prop 13x15 LH 1 inch shaft
    By Howard77 in forum Parts 4 Sale
    Replies: 0
    Last Post: 08-10-2007, 08:21 AM
  3. Wanted: 4 blade 24 or 25 pitch prop
    By prozach in forum Sandbar
    Replies: 2
    Last Post: 08-06-2005, 12:02 PM
  4. wanted 26 4-blade prop
    By rvrjunkie in forum Out Drive
    Replies: 11
    Last Post: 03-24-2005, 10:30 AM
  5. Free - drive shaft, 3 blade prop, prop strut
    By tornreality in forum V-Drives
    Replies: 3
    Last Post: 03-12-2005, 04:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •