I have 2 cracked heads due to overheat (long story). Now in the market for replacement. Gen VI 502 block (casting 10237300) and the bad heads are Gen V cast iron (casting 14097088).
What are the pros and cons of aluminum vs iron on the heads? I have the roller cam with 580 lift, 240 duration, Vic Jr. air gap, Holley 850, EMI Thunder, MSD, Berk 12JG w/ plate, A/B mag/bronze, shoe, diverter spinning about 5,100 rpms in tight pump.
In my 20.5' Caribbean last saw 72.3 on GPS before mishap. The old heads have roller rockers/springs etc. matched to the cam. Looking to swap hardware to new heads.
I've searched and looks like some cheap Chinese stuff on market (Pro Comp?) for less than $1k. GM is quoting $1,500 for bare iron direct replacement.
Which way to go in my pedestrian lake boat, GM iron, Dart, off-brand aluminum? If I have to go to the hip, might as well add some H.P. Any opinions?
aluminum all the way. weight savings alone is a bunch.i have been running 2 sets of the procomps 1 set for 2 years now and 1 set for about 4 months on different boats.very happy with them alot of the peeps on here hate them and say they are junk b/c of a few stories they have herd or read.or b/c they are from overseas were everything else they have has some part of it made outside the us they just wont admit it or dont know they whole thruth.:idea:
you can run up to 1 more compression with aluminum heads than cast iron without detination worries they will cooler and more timing than cast iron,they are just a whole different world and so much better.i would not pay that much for cast when you can go alm.for not much more im sure that alot of peeps will help you out on this one and i wish you the best in whatever way you choose.remember the key to any good heads is the feller setting them up.i would double check any and everything someone else does no matter if you buy pro-comp,dart,brodix,edelbrock no matter have a nother head shop recheck everything they have done.i do this everytime we get heads done you will suprised what you can find,:jawdrop: later travis