Results 1 to 5 of 5

Thread: Running Torquer II Manifold

  1. #1
    SPECTRA77
    I have a 460 Ford engine, this what I am thinking to rebuild with 24cc dished pistons and stock cam:The M-6250-A460 Hydraulic Flat Tappet Cam = 0.493" Intake, 0.502" Exhaust and 216°@.050" Intake, 220°@.050 Exhaust.
    I am going to do some minor porting on head and keep stock size valves.
    The reason for the 24cc pistons is the compression ratio low to run unleaded gas. I have Edelbrock Torquer II Manifold that would clear my low engine cover.
    Has anyone run a Torquer Maifold, I know that on 455 Oldsmobile quite a few people have run the Torquer Manifold.

  2. #2
    GunninGopher
    I had one on my last Jet. I also had the heads done with bigger valves. If I were to do that today I'd probably use an Edlebrock Performer RPM Air Gap.
    It worked OK, but I couldn't tell you how much of it had to do with the intake.

  3. #3
    SPECTRA77
    I had one on my last Jet. I also had the heads done with bigger valves. If I were to do that today I'd probably use an Edlebrock Performer RPM Air Gap.
    It worked OK, but I couldn't tell you how much of it had to do with the intake.
    I do not have space to fit an RPM Air Gap, what was the rpm you were turning?

  4. #4
    Cas
    not sure if you have room but the Weiand Stealth intake works well on the 460's.

  5. #5
    camoman
    not sure if you have room but the Weiand Stealth intake works well on the 460's.
    Yah Victors work good to

Similar Threads

  1. bbc manifold
    By slotracer in forum Parts 4 Sale
    Replies: 16
    Last Post: 12-15-2007, 06:14 AM
  2. Anybody here Jet Hot an Intake Manifold?
    By cave in forum Jet Boats
    Replies: 29
    Last Post: 06-07-2007, 08:25 AM
  3. blower manifold
    By jet4fun in forum V-Drives
    Replies: 4
    Last Post: 06-14-2006, 08:39 PM
  4. gil manifold ASAP
    By 38cig in forum Parts 4 Sale
    Replies: 1
    Last Post: 06-06-2006, 02:06 PM
  5. Manifold Vaccum
    By Taylorman in forum Gear Heads
    Replies: 4
    Last Post: 07-02-2005, 06:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •