kinda amazing I haven't been permenatly banned from this place...
There's still time.
kinda amazing I haven't been permenatly banned from this place...
kinda amazing I haven't been permenatly banned from this place...
There's still time.
There's still time.
With the Big Block Ford cam drive kit I ordered from you...
Before...
http://***boat.com/forums/attachment...1&d=1196913945
I had my buddy Richard throw the part in his Haas CNC mill:
http://www.twistedmetalcnc.com/
And after:
http://***boat.com/forums/attachment...1&d=1197052615
A Big Block Ford Magnaflow water pump drive for my cam... There is no way I could have used the part without removing the big flange. It would have worked fine if I werent planning on running a mechanical fuel pump. I wanted to remove as much of the imbalance off of the cam as possible by having just a small blip for the dowel pin remaining.
http://***boat.com/forums/attachment...1&d=1197052681
http://***boat.com/forums/attachment...1&d=1197052782
I wanted to keep the blip on the part so that I could use the extra room in the dowel hole to pin the pump drive in place. I also like the idea of having the brass cup holding the pump drive coupler / cap screw in the event something would come loose at sustaned 10,000RPM jaunts. :devil:
The way the brass cup nests into the timing cover I dont thing the parts can go anywhere if something were to break, it all stacks together real nice.
Call or e-mail Richard if you need any help machining parts...
http://www.twistedmetalcnc.com/
WTF is going on with this website Tom Brown???????????????
WTF is going on with this website Tom Brown???????????????
speaking of which I finally got paid on a job I was trying to collect on for about 6 months... :notam:
Acid is a helluva drug...:messedup: