Results 1 to 2 of 2

Thread: Removing the power steering ram on Bravo 1

  1. #1
    tucson_boat_guy
    Hey all,
    Wonder if I can get some tip on removing this ram so I can replace it. Maybe a few hints on what to leave and what is needed.
    Also what is the best way to remove all of the fluid to change it after I get the new one installed.
    Thanks

  2. #2
    pocketchange 22
    Remove the (2) lock tabs on bolts (like 1'') one upper, one underneath. On the end of the cable remove the pin attatched to the tiller arm, unscrew the power steering lines, drain fluid into cup, unscrew the steering cable from ram then slide cable out. Steering ram will be in your hands by now. replace with new ram and don't forget to fill power steering pump with New fluid.:devil:

Similar Threads

  1. Bravo-1 Power steering failure
    By Beer-30 in forum Out Drive
    Replies: 5
    Last Post: 09-13-2007, 07:53 PM
  2. Removing Bravo I Drive (special tools?)
    By JoeB in forum Out Drive
    Replies: 7
    Last Post: 08-29-2006, 03:38 AM
  3. Help my power steering is out!
    By Perfect Mixer in forum Sandbar
    Replies: 4
    Last Post: 06-21-2006, 09:13 PM
  4. need mercr. bravo steering tie bar
    By mrcrsr in forum Out Drive
    Replies: 0
    Last Post: 10-01-2005, 06:53 PM
  5. Help I'm Stuck! Removing Teleflex Steering
    By Elk Chaser in forum Jet Boats
    Replies: 4
    Last Post: 09-06-2003, 05:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •