JIm Brock @ Cyclone Speed & Marine has had a few Southwind Tunnels. JIm has lots of parts & should be able to help you with your needs.
JIm's # is 818-890-1867
Brent
Hello everyone, I am new to these boards but have been lurking for awhile. I have a new project and am looking for info from the fine people here at the Hot Boat site. My project boat looks like a southwind dragstar tunnel but the registration shows as SSHNE first registered in 1983. Any info would be greatly appreciated: manufacturer, set-up, restoration, etc. The boat is complete less engine. I am looking for a Chevy 454 Mark IV short block, mounts for a rail kit, and dominator pump parts. Thanks in advance for any assistance.
JIm Brock @ Cyclone Speed & Marine has had a few Southwind Tunnels. JIm has lots of parts & should be able to help you with your needs.
JIm's # is 818-890-1867
Brent
if it's an '83, it could very well be a Mach 1. same mold, but the bottom is different.
Thanks for the help, I'll give him a call.
[ November 15, 2002, 07:46 AM: Message edited by: Pman ]
i have a set of motor rails. blue anodized..
I have a complete rail kit for bb chevy out of southwind tunnel, gold anodized. Jim Brock (818)890-1867
I have a bronze "A" impeller from my Dominator Pump I would be willing to let go for a good price. Tim
HEY TIM YOU GOT A BEAVER. WHAZZUP WITH THE BEEV. eek!
Blown Olds,
No I don't have a beaver (pet or otherwise), it's just the mascot from my school (OSU), sometimes confused with U of O (Ducks, Eugene, etc). Tim wink