They are easy to make but are pretty cheep to buy.
look here
i NEED WATER INLET PLATES FOR A BBC I'M SURE SOMEBODYS GOT SOME LAYING ON THERE WORK BENCH IN THE WAY!!
THX,
MARK
P.S. SORRY ABOUT THE CAPS THE DAMN BUTTON IS STUCK
They are easy to make but are pretty cheep to buy.
look here
I'll make you a smokin forum member deal on one of my Aluminum BBC crossovers. I have 3 left with bowtie embossed on face and good stock on blank-faced model. Cleans up the plumbing and adding a thermo system is a snap. I've also run 3/8" lines to block drains to eliminate sand build-up.
Just trying to feed the kids (I said KIDS not kitty)
db
I posted a drawing of these plates a while back. If you have a milling machine you can make them in about 45 min. Also a DRO (digital readout) on the mill makes it even easier.
T.J.
www.tjsperformance.com