Since no responses yet, I'll pitch in. On the thrust bearing:
Need to remove the nozzle and bowl, impeller, then suction piece w/shaft. Then bearing cap and finally shaft. An arbor press is used to press the bearing off the shaft and to install the new one.
I recommend buying the Seloc manual for step by step instructions.
One important thing. The Seloc manual is unclear about which way the thrust bearing notch must be oriented. Some reference contradict others. Normally notch will be toward engine, but not always, depending on bearing manufacturer. So make sure you get this right or risk early bearing failure. I have pictures of the correct installation if you like.
BTW, I've never actually replaced a thrust bearing so this is all BRF info...use at your own risk http://free.***boat.net/ubb/smile.gif http://free.***boat.net/ubb/smile.gif
jer