I had the wate impeller shred itself on my Eliminator this weekend. I purchased a replacement kit and installed it. Unfortunately, I fired the boat up this morning and let it run for about 45 seconds and still no aqua out the pipes. I pulled everything apart again and nothing appears to be wrong. There a couple of small "tears" at the bottom of two of the fins, but I'm assuming that it is due to it being dry. I confirmed that the blades are bent the correct way to wipe the housing, but I'm confused on why it is not moving any water. Did I miss anything or is there something else that may be going on? How long should it take to prime and start to pump water? I'm frustrated as heck so any advice would surely be appreciated. Thanks Hot Boat.....