Well I sent out a few pieces of my project to get them anodized purple...I sent the cast timing chain cover and it looks horrible.....The other pieces for the air shift set up was polished 6061 and it turned out very nice...From what I have seen on all the parts the powder looks way better than anodized. I have not sent the rails or engine mounts and all of the other parts made out of 6061 down yet.........I don't know if I want to powder or ano the rest...
Does anyone know the best place to go??? I have over 22k in the engine and don't want a bad job done on the parts......who would be the best and which way should I go. It's a sanger true flat that I plant to run as a lake hot rod for about a year or two..at the most...then the engine will go in a 501 hydro..............I need some help here......thanks