Every hose on mine is 5/8, and those are factory, so when i finally go all braided, it will be -10AN.
thanks alien i knew sizes but did not know how they came up with them
87 sleekcraft
Every hose on mine is 5/8, and those are factory, so when i finally go all braided, it will be -10AN.
Thanks for the replies everybody, that was alot of help...
Cool, Now I know I can go with # -10 since all my water hoses are 5/8". Thanks!
Think of it in 1/16's
-8 = 8 - 1/16's or 1/2 inch
-10 = 10 - 1/16's or 5/8 inch
-12 = 12 - 1/16's or 3/4 inch
etc . . .
GOT IT
_____
-8AN here. I've got a valve on it to reduce the flow to the motor, but I leave it wide open. Never had a problem with too much, or too little water.
Picture shows -8 in (top line) supply from pump to motor and -8 dump (bottom line). Both valved, but both kept wide open at all times. For mine -8 seems to be the perfect size.
http://www.homestead.com/jetboat/files/img_0342e.jpg
What motor are you running? or does it matter?
-8AN here. I've got a valve on it to reduce the flow to the motor, but I leave it wide open. Never had a problem with too much, or too little water.
Picture shows -8 in (top line) supply from pump to motor and -8 dump (bottom line). Both valved, but both kept wide open at all times. For mine -8 seems to be the perfect size.
http://www.homestead.com/jetboat/files/img_0342e.jpg
It's a 466 BBF with around 500 hp. It spins an Aggressor AB to about 5200-5300 rpm. I wouldn't think it would make a difference from one motor to the next though.
Well, until I switch everything over to braided lines, I'll just use the 5/8" rubber hose already there, WHEN my motor gets back from the shop. Hopefully this week. SUmmer's almost gone and I've only had it out once since I bought it.
It's a 466 BBF with around 500 hp. It spins an Aggressor AB to about 5200-5300 rpm. I wouldn't think it would make a difference from one motor to the next though.