It should be tight enough not to move. Is the rubber insulator there? It goes around the front bearing housing. The bellhousing clamps around that.
on a 3 point mount set up how tight should the rear mount on the jet be?
thanks
pat(slotracer) :2purples:
It should be tight enough not to move. Is the rubber insulator there? It goes around the front bearing housing. The bellhousing clamps around that.
put a new doughnut on it today and i can still move the engine. it's snug but not real tight.
pat(slotracer) :hammer2:
That sounds about right.
thanks craig. are you going to make hogan?
pat(slotracer) :boxed:
Probably not. Still no seats. Been dragging my heels. :frown:
seats who needs seats. put a milk carton in it with a pillow :idea:
pat(slotracer) :eat: