thanks heavyboat!
i got your #'s from a post you did a few yrs ago.something to compare the flow and restrictions on.
you may have read my post i am getting 14lbs with 18% over.i am going to the dyno tomorrow and will post some results.i have a blowershop 8-71 with 3 strips per rotor.i had a BDS stage 2 but it would only flow 10lbs at 14% overdrive.
thanks for taking the time!!i hope things are going well for you!
update:
OK first the #'s then the excuses.
3 runs.all had the spark breakingup.
1]559hp/574tq88pri/90sec jets A/F les than 10/1
2]579hp/606tq 88pri/86 sec A/F under 10/1
3]555hp/584tq 88pri/83 sec jets A/F under 10/1
the plug gap is .035ngk #8 mallery 29440 coil7ALign box.
i did not think to gap the plugs less.
i got no rpm with the chart due to the spark blowing out.the motor kicked pritty good a couple of times and realy stressed me out if it was ok.
i need to change the plug gap and the coil i have a MSD pro power coil # 8201 in the box still.
ok have at me for my neglect.
i would have changed the plugs but it takes a while and i had no time on the dyno left.
these peak #'s are at 4,000 rpm