Leave it to Rex to bring up the past! Here's some new found locktite: GOOP! smear it on the threads after the cotter pin....it streamlines the water flow over the rough edges....better than smile_sp welding.
Whew!!!!!!!!! Now that was a lot of info in a short time. Nyloc with cotter pin, and a jambnut if there's room. Thanks.
Leave it to Rex to bring up the past! Here's some new found locktite: GOOP! smear it on the threads after the cotter pin....it streamlines the water flow over the rough edges....better than smile_sp welding.
Her will be checking all the prop nuts for looseness I hear at the next CFW event.
[ July 22, 2003, 08:36 PM: Message edited by: Rexone ]
Rexone:
Her will be checking all the prop nuts for looseness I hear at the next CFW event. Sorry, but I'll be only checking one that I know of.....