PDA

View Full Version : Rhino Question



28Prowler525
02-12-2007, 08:11 AM
I know some of you have run into this problem, so I figured an answer is out here somewhere.
I have a 74" clearance to the pull down bed in the back of the 5th wheel, and the Rhino roll cage is around 73". I am pretty sure will hit the bed, since it is coming into the trailer at an angle.
How has everyone delt with this issue? Does anyone make a low profile cage?

CornWater
02-12-2007, 08:48 AM
I know some of you have run into this problem, so I figured an answer is out here somewhere.
I have a 74" clearance to the pull down bed in the back of the 5th wheel, and the Rhino roll cage is around 73". I am pretty sure will hit the bed, since it is coming into the trailer at an angle.
How has everyone delt with this issue? Does anyone make a low profile cage?
Coming in at an angle does'nt make it any taller.. it will fit fine.

Magic34
02-12-2007, 08:51 AM
Todd's Custom Billet makes a cage that is 2 inches lower than stock as does many other cage mfgs as well.
As said above, you shouldn't have an issue though.
If you are worried at all about it, let air out of your tires and you will get another inch or so.

28Prowler525
02-12-2007, 09:30 AM
Thanks Guys