Outboard Brackets

[BoatFloating]

Other than the backing plates what else is inside the boat? Do you have anything that would attach to the stringers?

[Dana Marine Products]

With any of our big twin or triple engine billet brackets we use a series of inside supports from the bracket to the stringers. They are made to each boat specifically.

[BoatFloating]

Thanks for the info Bob.... Tell Dana Rocky said hi....

[full throttle]

Got any pics of these outboard brackets?

[BoatFloating]

Got any pics of these outboard brackets?
They are on their web site.

[Dana Marine Products]

Here's a couple that we've recently done. This one is a triple with a center jackplate.
http://www.***boat.com/forums/attachment.php?attachmentid=24750&stc=1&d=1172258830
http://www.***boat.com/forums/attachment.php?attachmentid=24751&stc=1&d=1172258842
http://www.***boat.com/forums/attachment.php?attachmentid=24749&d=1172258817

[Dana Marine Products]

Here's a triple stationary and the mounting straps inside the boat.
http://www.***boat.com/forums/attachment.php?attachmentid=24754&stc=1&d=1172259115
http://www.***boat.com/forums/attachment.php?attachmentid=24755&d=1172259159
http://www.***boat.com/forums/attachment.php?attachmentid=24756&d=1172259203

[BoatFloating]

Very nice..... What boat was this put on?

[phebus]

Rocky, why do you need brackets? I heard Lakeland had you set up just right. :D

[Dana Marine Products]

Both were Eliminator Daytona's. One 30 and one 33.

[BoatFloating]

Rocky, why do you need brackets? I heard Lakeland had you set up just right. :D
You mean their skill saw custom redo of the billet brackets.....:mad:

[RiverDave]

Here's a couple that we've recently done. This one is a triple with a center jackplate.
http://www.***boat.com/forums/attachment.php?attachmentid=24750&stc=1&d=1172258830
http://www.***boat.com/forums/attachment.php?attachmentid=24751&stc=1&d=1172258842
http://www.***boat.com/forums/attachment.php?attachmentid=24749&d=1172258817
Just for my own curiosities sake. Are their sliding mounts on the outside of this as well? (I'm assuming there would have to be?) Or does that whole program just ride up and down in the center?
Looks bitchen by the way!
RD

[Dana Marine Products]

On this bracket the outbound motors are stationary. We have built brackets where all three engines move, but this one was built for the center motor to move only.

[RiverDave]

Very cool. Nice looking work!
RD

[JPA]

Those brackets look really sharp ,..how much does a single bracket weight?

[Dana Marine Products]

A single stationary bracket weighs roughly 50 lbs and a single hydraulic jackplate weighs roughly 75-80 lbs