View Full Version : Drilling thru Powder coating
copterzach
06-10-2007, 09:03 PM
I just bought a set of powder coated valve covers and I need to drill holes to mount the breather. What is the best way to do it so that I do not mess up the powder coat?
Dana Marine Products
06-11-2007, 07:48 AM
Hi, use some blue 3M masking tape and tape of the desired drill area. Be sure to put enough tape to avoid the spinning metal from marking up the valve cover.
Thanks,
Bob
copterzach
06-11-2007, 12:22 PM
Thanks! They look very nice
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.