Printable View
These are the tools that Jim (Maguyver) used to make an emergency plug, for my boat at lake ming. We were the next boat to launch when he noticed that my center plug was missing. He found the screwdriver, wraped plumbers tape around it, and drove it into the hole, with the 22 oz framing hammer.
The plug held and I had my best run of the weekend.
http://www.hotboatpics.com/pics/data...ever-thumb.jpg
beumont now has a new master mechanic ... lmao -- glad ya had no problmes - would sucked if you where up the gourge ... i guess as long as you didn't stop all was good
These are the tools that Jim (Maguyver) used to make an emergency plug, for my boat at lake ming. We were the next boat to launch when he noticed that my center plug was missing. He found the screwdriver, wraped plumbers tape around it, and drove it into the hole, with the 22 oz framing hammer.
The plug held and I had my best run of the weekend.
http://www.hotboatpics.com/pics/data...ever-thumb.jpg
I was sitting behind you guys at the ramp watching the whole event unfold. I immediately thought of McGyver as I watched your buddy hammer that screwdriver into the transom of your boat. Then I kept an eye on your boat while we were on the rope to see if it was going to sink. glad it didn't!
Cyclone,
No wonder your reaction time stank, too busy watching to Bahner. "Watch the Lights"!!!!!!!
Jeanyus,
And I thought my day was going well now. You just had to bring shit like that up. Now oldrigger is gonna give me a hard time about using a framing hammer, screwdriver and duct tape on a classic Bahner. :cry:
Jim
nice save.
are these Stock seats in your Bahner ? they seem to all have the 2 Buckets with Side seats. haven't seen this in a Bahner. (lots of others though)
http://www.hotboatpics.com/pics/data/2/5859boat4.jpg
Cyclone thanks for keeping on eye on my sinking boat, can't remember what you look like, but I will be at ming again.
Bahner Jet, the seats were like that when I got the boat. BTW I bought the boat on E-bay
http://www.hotboatpics.com/pics/data...bahner-med.JPG
It had pads attached to the fenders and frame on the trailer, to protect from rock chips, the pads caused a lot of rust on the trailer.
before
http://www.hotboatpics.com/pics/data...9oldbahner.JPG
After
http://www.hotboatpics.com/pics/data/500/5859bbcs.jpg
I usually use the titanium death stick but that is just me. Glad to hear it worked out.