Printable View
I'm in the process I going through my fuel system and want to send my injectors in for refurbishing. My question is twofold . 1. How do I get these suckers out once I've got the fuel rails off? (Accel multi port system) and 2. any recommendations on a good shop to send them to?
the injectors should just pull out of the rails. there might be some metal clips holding them on but no special tools needed. RC Engineering or RC injectors is the place to call. they are in socal..
They are just in there with O-rings. If you take a piece of wood or plastic and gently pry up on the bottom of the wide part of the injector body, they will just slide right up. Make sure the fuel rail is loose, and just lift all the injectors out of the manifold - leaving them attached to the rail(s). Then, they all come out as one piece and you can take them out of the fuel rail one by one on the workbench.