-
Goose I don't know of anybody in the Valley, I would call Gary at GT and see if he has any openings. You could ran your boat down to him straight out the 10fwy on a Saturday morning and it wouldn't take you very long. He might squeeze you in.
I wouldn't run that boat at all until it was fixed. If you get a little salt water or any water in there it could be bad news and more $$$$$$$$ for nothing. Call Gary and bring that 29' out next time.
Andy
-
Goose I don't know of anybody in the Valley, I would call Gary at GT and see if he has any openings. You could ran your boat down to him straight out the 10fwy on a Saturday morning and it wouldn't take you very long. He might squeeze you in.
I wouldn't run that boat at all until it was fixed. If you get a little salt water or any water in there it could be bad news and more $$$$$$$$ for nothing. Call Gary and bring that 29' out next time.
Andy
Do you have the number for them??????
-
Give Eric at Maveric Marine. They do awesome quality work. The shop is in Van Nuys. (818) 989-4445. Tell him Dave Craig referred you.
-
Do you have the number for them??????
Here's you go Gary @ GT Performance 909-982-8391. Wouldn't take my boat anywhere else.
Andy
-
Give Eric at Maveric Marine. They do awesome quality work. The shop is in Van Nuys. (818) 989-4445. Tell him Dave Craig referred you.
I tried him this morning ,and he said he doesn't work on outboards anymore.
-
you could always try B&D Marine in El Monte......Brian knows his way around boats very well, I've always had good luck there...
my $.02 :D
-
Here's you go Gary @ GT Performance 909-982-8391. Wouldn't take my boat anywhere else.
Andy
Thanks for the info Andy, Have a great day in the big blue. Scotty just sent me a PM. Said he is going to be Jeff's boat BIAATCHH for sunday.
-
I tried him this morning ,and he said he doesn't work on outboards anymore.
Hmmm. Guess he doesn't like re-stringin whaka's anymore... :)
-
I tried him this morning ,and he said he doesn't work on outboards anymore.
What do you need done?Just a propshaft seal?
-
What do you need done?Just a propshaft seal?
No, I have gone through 3 seals in 4 weekends. Ritchy at lakeland replaced them. He told me the last time that he thinks the whole bottom end seems a little loose to him. said to give this last one a try and if it leaked again he would try and get mercury to replace the bottom end. seemed to be fine after the poker run so I brought it back to valencia. got home and a day later noticed it leaking again on the floor. not much, just a spot about the size of a silver dollar. I don't have time to take it back to havasu before memorial day. Going to nacimento. Then to the mohave dam run. not sure it will make it through 2 weekends.