-
kid this is dedicated to you
1.crack the block making it a 4 bolt main ,the outside bolts need to be smaller ,cant be same size
2.get motor done 30 over 11 1/4 pistons 8-71 30 pound boost on alky,lays the crank on the dyno room floor with main caps still bolted ripped webbing out of the block
3.redo different block and crank steel rods,30lbs boost anhd custom main girdle[the block had to be deffective]pulls great till at 500rpm bam crank on the shop floor agian,same deal caps attached
4.redo motor 20lbs of boost pulls till 7000rpm going great let of throttle and load bam crank snout breaks and main studs wont come out of the block,reading back it 5000rpm on #3
5.i will be trying at 10lbs of boost later this month cant afford it right now,kuhl and littlefield say it will live as long as its below 15lbs ,15 is the limit for that block if i win the lotto ill get the aluminum block that can hold it till then i have to pay a mortgage on the basement i live in :D
kid i will be at anna on fathers day to run you,i might not beat you this year but it will be closer than you think at the finish line
-
Did u get a boat? Hydro on sale $7500 :cool:
-
got a boat,2003 tx-20 warhawk tunnel
-
-
[ September 20, 2002, 09:35 PM: Message edited by: Alias ]
-
Lets see the pictures Nitro...... wink
