The diagram will be on the bottom or side of the relay.
Hello everyone, I was hoping someone could tell me how to wire up a bosch relay. I am planning on putting my fuel pump on a switch up front but I dont really want to have its power run all the way up front and then all the way back to the engine compartment. I would like to put a relay in the engine compartment and just have 2 little wires running to the front to switch the relay, just like my hatch motors. Hope someone can help.
AL
The diagram will be on the bottom or side of the relay.
Hey you guys are the best, im all over it thanks.
Al
http://www.6066gmctrucks.org/electri...ayCircuits.jpg
Damn Wire Jockey.....
Atleast you didn't say internet wire jockey
You the man HH
Atleast you didn't say internet wire jockey
You the man HH
I knew I forgot something.
HH, you damn internet wire jockey :wink:
Anyone have a diagram to wire a bosche relay from a head unit to a fused distribution block?
Anyone have a diagram to wire a bosche relay from a head unit to a fused distribution block?
Slick, Slick, Slick....
86 is to the remote turn on lead from the headunit(fuse it)
87 comes from your constant 12v(fuse it); Mostlikely your battery. Make sure you have a large enough wire to cover all of your fused circuits 8 or 10ga if you have a lot...
85 is your ground
30 goes to your fused barrier strip. Again, make sure the wire ga is correct for your load...
do I need to run a suppression diode? I'm having issues with the remote lead since trying to change the configuration. Who'd a thought I'd have so much trouble trying to do it "the right way".