I finally got enough warm weather to glue the jet back into my CVX 20. Next step is to install the Big Bad Ford. So before starting I want to get any suggestions, tips etc that anyone will offer. I have some initial questions that I could use clarity on. Like, I assume I bolt the driveshaft to the engine first & then slide it onto the pump shaft. is it easier to put the rubber exhaust in before or after the engine is set in place? Any other BOAT ONLY considerations when setting an engine? I have been R&R ing auto engines most of my life but this is the first marine app and I would like to get ahead of the learning curve on this one cause I really really want to get this boat wet.