I was crawling around under the new Daytona last night checking stuff out and I noticed that there were two little gouges about .030" deep in the suction piece where the loader has evidently been bumping it. The loader itself doesn't appear to have any marks or worn spots on it but I am not certain that this is the loader that caused the damage because the boat came with three different ones, however the marks do line up with this loader. Do loaders flex enough at speed to cause this? Is there anyway to secure the loader so that this doesn't happen, like adding another screw or two somewhere? Should I just grind off some of the loader so it doesn't get into the housing? I need some help guys. Thanks!