Results 1 to 4 of 4

Thread: Blowndeaver Has New Kurtis 500

  1. #1
    BLOWNDEAVER
    HELLO , I need help on motor placement ,kurtis500 or someone with one of these please help, also need 12 spline flange for v drive to drive shaft, thanks alot

  2. #2
    Senior Member
    Join Date
    Feb 2009
    Location
    Irvine, CA
    Posts
    2,885
    You need to get a hold of Norm Grimes ... Glendale, CA. I don't have his number on me but I'll PM you with it later when I get over to my shop.
    Brian

  3. #3
    Kurtis500
    Blowndeaver, I assume its the k500 hydro, not flat. If you need me too, I can go measure my Kurtis 500. Let me know which measurements. V-drive to motor, v-drive to rear of boat, motor from rear of boat.

  4. #4
    BLOWNDEAVER
    Blowndeaver, I assume its the k500 hydro, not flat. If you need me too, I can go measure my Kurtis 500. Let me know which measurements. V-drive to motor, v-drive to rear of boat, motor from rear of boat.YES HYDRO, I WOULD LIKE BACK OF BOAT TO MOTOR,BACK OF BOAT TO V DRIVE, AND TOTAL LENGHT THANKS ALOT THOMAS

Similar Threads

  1. BA Kurtis
    By v-drive in forum V-Drives
    Replies: 2
    Last Post: 06-20-2007, 06:23 PM
  2. BA Kurtis
    By pebo in forum V-Drives
    Replies: 1
    Last Post: 04-15-2007, 02:14 PM
  3. kurtis 784
    By hondo Jim in forum V-Drives
    Replies: 19
    Last Post: 03-06-2007, 05:46 AM
  4. kurtis 784
    By hondo Jim in forum V-Drives
    Replies: 30
    Last Post: 02-26-2007, 08:38 PM
  5. Kurtis 501?
    By Willis in forum V-Drives
    Replies: 4
    Last Post: 12-11-2004, 07:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •