Results 1 to 10 of 10

Thread: pulling droop for zerk?

  1. #1
    Riverat84
    i found the zerk fitting on my aggressor bowl, but cant access it cuz of the middle wall in my droop that (i guess) prevents the tumble/roll of water....does that mean i have to pull the droop/nozzle ass. ?
    cuz i have an assload of droop gaskets if i need to.
    Reid

  2. #2
    Squirtin Thunder
    Yes it is much easier !!!

  3. #3
    Riverat84
    alright, thanx jim...all i gotta worry about is the steering linkage right? i dont have to take off the lines/hydraulics? just have something to set the assembly on next to the bowl right? thanx.
    Reid

  4. #4
    Squirtin Thunder
    Yes !!!

  5. #5
    poncho-pwr
    Duct tape the end of your grease gun hose to a long screwdriver and give it a shot first, it should work. I do this to mine all the time.

  6. #6
    Riverat84
    yeah, but even w/ that, it didnt work...the 'wall' went all the way up to the nipple, so i had to take it off...nipple was rusted SHUT so i went and bought a new one and put it on....i took the big red nut off just to check how much would be in there, and water came out! like almost a cupfull! there was some grease way back in it, so i just pumped it until it was full....worked well! gasket fit great and its back on...thanx jim and poncho.
    Reid

  7. #7
    502 JET
    You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html

  8. #8
    Riverat84
    You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html
    hey thanx bud, ill check it out...the thing was totally rusted!
    Reid

  9. #9
    sanger rat
    If you use plastic wedges you don't need to mess with gaskets.

  10. #10
    Squirtin Thunder
    If you use plastic wedges you don't need to mess with gaskets.
    Package on the way !!! :yuk:

Similar Threads

  1. 20.5 Advantage droop or no droop?
    By wright27 in forum Jet Boats
    Replies: 2
    Last Post: 05-30-2007, 01:00 PM
  2. Pulling a SBC 350 for the first time.
    By Sand Dawg in forum Gear Heads
    Replies: 17
    Last Post: 07-19-2006, 05:06 AM
  3. place droop vs. berk. droop
    By Hardin18 II in forum Jet Boats
    Replies: 10
    Last Post: 03-27-2005, 09:43 AM
  4. Who are you pulling for tomorrow?
    By Boozer in forum Sandbar
    Replies: 26
    Last Post: 01-09-2005, 11:36 AM
  5. Zerk fitting on Berkeleys
    By Inciong_A in forum Bench Racers
    Replies: 13
    Last Post: 07-17-2001, 04:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •