Yes it is much easier !!!
i found the zerk fitting on my aggressor bowl, but cant access it cuz of the middle wall in my droop that (i guess) prevents the tumble/roll of water....does that mean i have to pull the droop/nozzle ass. ?
cuz i have an assload of droop gaskets if i need to.
Reid
Yes it is much easier !!!
alright, thanx jim...all i gotta worry about is the steering linkage right? i dont have to take off the lines/hydraulics? just have something to set the assembly on next to the bowl right? thanx.
Reid
Yes !!!
Duct tape the end of your grease gun hose to a long screwdriver and give it a shot first, it should work. I do this to mine all the time.
yeah, but even w/ that, it didnt work...the 'wall' went all the way up to the nipple, so i had to take it off...nipple was rusted SHUT so i went and bought a new one and put it on....i took the big red nut off just to check how much would be in there, and water came out! like almost a cupfull! there was some grease way back in it, so i just pumped it until it was full....worked well! gasket fit great and its back on...thanx jim and poncho.
Reid
You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html
You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html
hey thanx bud, ill check it out...the thing was totally rusted!
Reid
If you use plastic wedges you don't need to mess with gaskets.
If you use plastic wedges you don't need to mess with gaskets.
Package on the way !!! :yuk: