>>>>NEED HELP QUICK<<<<<<

[GHTRIM]

Detailing the boat getting it ready for the Dam Run and noticed a hole in the bottom of the boat... Actually I believe it is a factory defect.. The Gell is SOOOO thin in this location no marks around it and some void behind it. I still think it need to be addressed ASAP!!!! Just pulled the boat from Havi and it is now in Vegas.... Need someone to help...
Thanks for any help ya'll can give... :jawdrop:

[HOOTER SLED-]

Duct tape. Just kidding. Good luck man. See ya there. I'm sure there is some kind of filler you can put for temporary.

[Kachina26]

Got a pic of this hole? Where is it? On the running surface?

[GHTRIM]

Got a pic of this hole? Where is it? On the running surface?
Hang on I'll go take a pic.. It is on the bottom...

[Havasu Hangin']

If the gel hasn't peeled off by now...

[GHTRIM]

Here they are the one that looks read was me trying to block SOME of the flash with my finger so as not to get too much glare...
http://www2.***boat.com/image_center...oat_Hole_1.jpg
http://www2.***boat.com/image_center...oat_Hole_2.jpg
http://www2.***boat.com/image_center...oat_Hole_3.jpg
Thanks for any help..

[GHTRIM]

Duct tape. Just kidding. Good luck man. See ya there. I'm sure there is some kind of filler you can put for temporary.
Yea, I'm willing to go with the Beaumont fix for the short term (temp fix) although if I can get a real fix in short order that would be best.. :notam:

[phebus]

Most likely a blister in the gel. Cosmetic only, but I would have it looked at.

[Phat Matt]

Is it soft there or just the gel scraped off?

[Beer-30]

Hard to tell from the pics, but are those more blisters fore and aft of the damaged section? Looks like more in the future?