Smash, How do I get a hold of Eagle. I want to see that 21ft. cat you speek of...
What do ya think Jer,
Halt work on Flat Broke and pick up the 19' Daytona in trade for my hulk(with finished interior minus the MPD pump and Mill? I'ts only running 9.1:1 on forged goodies, so a huffer or juice is very doable... I think Em would kill me, but then again, she's never been over 65. She just might like it 8-)
Greg,
Could you get me some pics of the daytona hull and what you're asking. I'll be honest and say that me picking it up is a long shot, but I am curious to see what the girlfriend thinks. You can email pics and info to me at Chris@povertylineracing.com
Chris
[This message has been edited by flat broke (edited September 27, 2001).]
Smash, How do I get a hold of Eagle. I want to see that 21ft. cat you speek of...
Hey guys any info on that 383 sbc will help me get next years motor ready , I am keeping this short in case it fails again!1
Well , after being informed that I am not registered a couple of times I will try again , I am planning a 383 sbc for my 16ft Tahiti and would like some input from anyone who has a kickin small block , I understand that torque is where it's at and I would like to find out if I can get 70 or better . I am currently running a stock 350 which can do 59 on the gps in 6 seconds I think I can do better , opinions? mawnster@cfw.com please E-mail I can only check the forum once a week