Getting ready to install jetaway and was wondering if I could remove the H I have and just have one u-joint. This would take 2-3/4 of an inch off my drive line. Thanks Shawn
Yes, a lot of guys do it. I run my boat that way, and it's over 1000 hp. Slide your driveline on to the Jetaway, fasten your front motor mounts down, then just lift the back of the engine until the weight is off of the drive line, and that is where you lock down the rear motor mount.
Thanks for the info thats what ill do.
Sounds like your making alot of progress Bailey , didn't get to see you @ Red Bluff. Jim
Not enough progress, been waiting over a year for my motor being built. Still not done but getting close so I figured I'd install my rail kit and jetaway. Saw your boat at red bluff but you where never around when I came by.
Posting Permissions
Reply With Quote