I would call 1-817-467-7171 and ask David Reher as he has a ton of experience with those blocks and is a Wizard in his own right.
I'm building a blown alcohol motor for a river race boat. I'm using a KB600 block with a 4.600" bore and .500" studs. The o-rings are centered in the sleeve. The problem is with the large bore and studs there is barely enough room to get the o-rings past the studs and there is maybe .050" of gasket. To make matters worse, the bore on the gaskets is 4.030". I'm worried that the gasket will blow out. How much gasket do I need to get a good seal with the o-rings?
I would call 1-817-467-7171 and ask David Reher as he has a ton of experience with those blocks and is a Wizard in his own right.
call SCE gaskets
contact Ryan Hunter (owner) they will set you up or give you the info you need.
1-888-GASKET-1
scegaskets.com
How bout this?
http://www.scegaskets.com/images/prod/bod-pic-ics-2.jpg
http://www.scegaskets.com/images/prod/bod-pic-ics-3.jpg
http://www.scegaskets.com/products/ics.html
Well thats pretty funny my Dad drew that drawing for SCE and the Titan ICS line.SCE is about two miles from my house.
If you do contact the "Hunter boys", please say HI! for me. I set up a "super eliminator" runnerbottom for them back in the 80's, and it was a nice boat. "Glory Days" was it's name.
I've seen that pic it's in Ryan's office.
Thanks guys for your suggestions, I'll make some calls and see what I can find out. By the way, in my original post I said the bore on the gasket was 4.030", that's obviously wrong, it's 4.630". Thanks again....