Reply With QuoteARS can o-ring wedges if you want
I wonder how much an already $89 wedge is going to cost
ARS can o-ring wedges if you want
ARS can o-ring wedges if you want
I wonder how much an already $89 wedge is going to cost
If you are having trouble blowing wedge gaskets, ( or plastic), Take your droop, snoot, or nozzle housing and your bowl and have the surface of them milled. Something is off. Be sure to make it a rough cut. Smoothe in those areas is not good. I've seen people who have never had a problem remove gaskets by sanding them off with an abrasive pad, After that they could not keep a gasket in them.
If you are having trouble blowing wedge gaskets, ( or plastic), Take your droop, snoot, or nozzle housing and your bowl and have the surface of them milled. Something is off. Be sure to make it a rough cut. Smoothe in those areas is not good. I've seen people who have never had a problem remove gaskets by sanding them off with an abrasive pad, After that they could not keep a gasket in them.
That's the best advice I've heard yet! Double drill them at the same time, if you have'nt done it yet. Budlight
Posting Permissions